NAMZ Custom Cycle builds plug-and-play wiring harnesses, extension kits and electrical components for Harley-Davidson. Its handlebar extension and connector kits are what make an ape hanger or bagger bar swap a bolt-in job instead of a splicing project.
Integrate an aftermarket amplifier seamlessly into your V-twin's audio system with the NAMZ Custom Cycle amp power audio harness. This comprehensive harness features a hi-lo converter, ground loop isolator, and a 3-foot RCA cable to deliver clean, line-level audio to your external amp.
Factory Harley-Davidson and Indian Motorcycle radios provide speaker-level output, which needs to be converted for use with external amplifiers. This NAMZ Custom Cycle harness simplifies the process, transforming your factory radio's output into a clean, line-level signal. The included ground loop isolator also helps eliminate unwanted noise, ensuring your audio system sounds its best.
Achieving clear, powerful audio on your V-twin requires more than just a good amplifier; it demands a clean signal path. This NAMZ Custom Cycle amp power audio harness is designed to provide just that, allowing your aftermarket amplifier to perform without distortion. The quality components ensure a robust and reliable connection, letting you enjoy your music on the open road without compromise.
What is the purpose of the hi-lo converter?
The hi-lo converter takes the speaker-level output from your factory radio and reduces it to a line-level signal, which is what external amplifiers require to operate without distortion or damage.
Will this harness eliminate all noise from my audio system?
The integrated ground loop isolator is designed to reduce noise caused by ground loops. While it addresses a common source of audio interference, other noise sources may require additional troubleshooting.
Is this compatible with my factory Harley-Davidson radio?
Yes, this harness is designed to adapt factory Harley-Davidson and Indian Motorcycle radios with an OEM 35-pin connector for rear speaker output to an external amplifier.
| BRAND | NAMZ Custom Cycle |
| TYPE | Electrical |
| SKU | 850-08193 |
| WEIGHT | 0.06 lb |
Fit perfect on my 2013 FLD. Cable is long enough to allow me to put the V&H Fuelpak in the left side cover and connect to another accessory under the seat without any sharp bends in the wiring.
I needed this splitter because I had to plug in both an FP3 (to retune after changing headers) and Jekill and Hyde mufflers (with an electronic valve) at the same time.<br />It works perfectly and was delivered in record time!
I am now able to have an accessory plug and my FP3 run at the same time.
Needed this so I could plug in my love jugs and Powervision at the same time. Works perfectly, I like that they didn’t make the wiring too short or too long. It’s just the correct length to be able plug your stuff in and stuff it up near the battery box behind the cover.
I ordered this because it said it would work on my bike, and it's the six pin. But it's not the six pin for the 22 model ODB. I assume it works, just not on mine unless there is another power connection I haven't seen yet.
It says it fits a 21 flht and it doesn?t the fit enemy description is wrong
