Harddrive 1 1/4" ape hanger handlebars in chrome, designed for V-twin cruisers with factory 1 1/4" riser setups. Drilled and dimpled throughout for internal cable routing and a clean modern look.
Fits 2006-up FXDWG, 2008-2013 FXDF, and 2006-2013 FLSTF/B Harley-Davidson models with OEM 1 1/4" risers. Can be adapted to other V-twin models using 1 1/4" risers and top clamp. Not compatible with Throttle By Wire models.
Yes, if your bike has the OEM 1 1/4" riser setup (FXDWG '06-up, FXDF '08-13, FLSTF/B '06-13). Other models need 1 1/4" risers and a top clamp adapter.
Yes — the bars are drilled and dimpled throughout to route throttle cables and wiring internally for a clean appearance.
No — these bars are not designed for Throttle By Wire (TBW) models. Check your bike's throttle system before ordering.
The bars taper from 1 1/4" at the clamp to 1" diameter at the grips where control levers mount.
If your bike has the stock 1 1/4" riser setup, no adapters needed. Other models require 1 1/4" risers and a top clamp to fit these bars.
| BRAND | Harddrive |
| TYPE | Handlebars |
| SKU | 820-54492 |
| WEIGHT | 7.05 lb |
These bars would be perfect in every way except that the hole at the bottom for the internal wiring is at the front of the horizontal tube and not on the underside. A real disappointment as it appears that the best way to get a set of bars with perfectly placed holes is to buy a set of dimpled bars and drill them yourself. Sorry folks ... just calling as I see it.
Got everything on and looks good but then it snowed. boooo
The only problem was the holes going in (upper) were a little small. Used a die grinder to open them up
Fit nice. The extensions weren’t quite long enough so I made my own and layered the to slide into the bars more easily.
handle bars had holes for wiring made it easy to wire up and install switches bars were good quality
Terrific product for the price. Immaculate condition on arrival, no burrs or sharp edges in the wiring holes. Prompt shipping as well. Very satisfied.
